This work numerically investigates how Y-shaped metallic fins embedded in a phase change material (PCM) reservoir affect the thermal management of lithium-ion batteries. The constructal design method was applied to evaluate the effects of the number of fins and Y-shaped bifurcation length (L 1) on the maximum battery temperature, temperature difference within the battery cell, and PCM utilization. The fin area was fixed at 10% of the PCM reservoir area, while the number of fins varied from 9 to 18 and L 1 from 1.0 to 2.0 mm. For a 5C discharge, the PCM reservoir without fins resulted in a maximum battery temperature of 51.9 degrees C and a liquid fraction of about 63%. Adding Y-shaped fins reduced the maximum temperature to about 43 degrees C and increased the liquid fraction to over 96%. The temperature difference within the battery cell was also reduced by up to 43% compared with the finless case. The number of fins had a stronger influence than the bifurcation length, with limited thermal improvements above 12 fins. Comparing 9 fins with L 1 = 1.0 mm and 18 fins with L 1 = 2.0 mm, the maximum temperature decreased by 1.53 degrees C. Adding fins also restricted the upward movement of melted PCM driven by natural convection, promoting a more uniform temperature distribution and a lower temperature at the battery/PCM interface.
Pereira, L.N., Borahel, R.D.S., Da Silva, D., Biserni, C., Isoldi, L.A., Dos Santos, E.D., et al. (2026). Thermal Performance of a PCM Reservoir with Y-Shaped Fins for Lithium-Ion Battery Thermal Management. APPLIED SCIENCES, 16(20), 1-21 [10.3390/app162010098].
Thermal Performance of a PCM Reservoir with Y-Shaped Fins for Lithium-Ion Battery Thermal Management
Biserni C.
;
2026
Abstract
This work numerically investigates how Y-shaped metallic fins embedded in a phase change material (PCM) reservoir affect the thermal management of lithium-ion batteries. The constructal design method was applied to evaluate the effects of the number of fins and Y-shaped bifurcation length (L 1) on the maximum battery temperature, temperature difference within the battery cell, and PCM utilization. The fin area was fixed at 10% of the PCM reservoir area, while the number of fins varied from 9 to 18 and L 1 from 1.0 to 2.0 mm. For a 5C discharge, the PCM reservoir without fins resulted in a maximum battery temperature of 51.9 degrees C and a liquid fraction of about 63%. Adding Y-shaped fins reduced the maximum temperature to about 43 degrees C and increased the liquid fraction to over 96%. The temperature difference within the battery cell was also reduced by up to 43% compared with the finless case. The number of fins had a stronger influence than the bifurcation length, with limited thermal improvements above 12 fins. Comparing 9 fins with L 1 = 1.0 mm and 18 fins with L 1 = 2.0 mm, the maximum temperature decreased by 1.53 degrees C. Adding fins also restricted the upward movement of melted PCM driven by natural convection, promoting a more uniform temperature distribution and a lower temperature at the battery/PCM interface.| File | Dimensione | Formato | |
|---|---|---|---|
|
Applied Sciences (1).pdf
accesso aperto
Tipo:
Versione (PDF) editoriale / Version Of Record
Licenza:
Licenza per Accesso Aperto. Creative Commons Attribuzione (CCBY)
Dimensione
1.52 MB
Formato
Adobe PDF
|
1.52 MB | Adobe PDF | Visualizza/Apri |
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.



