Fabrication of Thin Walls with and without Close Loop Control as a Function of Scan Strategy Via Direct Energy Deposition

Direct Energy Deposition (DED) is a technique used to fabricate metallic parts and is a subcategory of metal additive manufacturing. Despite of its vast advantages over traditional manufacturing the deployment at industrial level is still limited due to underlaying concerns of process stability and repeatability. In-situ monitor- ing, therefore, is indispensable while depositing via DED. The present experiment is a step towards enhancing our current understanding of the DED when coupled with a closed loop control system to control melt pool width for deposition of thin- walled structures, and as a function of scan strategy. 316L stainless steel powder was deposited on S235JR substrate. A total of 6 iterations are reported, out of many performed, of which 3 were without the closed loop control. Also, to understand the effect of scan strategy as a function of laser power. Two different scan strategies were employed for understanding of the issue i.e., unidirectional, and bidirectional. Apart from the geometrical consistency of the wall, microhardness, density calcula- tions and microstructure were investigated. The geometric consistency was found to be almost perfect with the bidirectional scan strategy. In case of unidirectional scan strategy, the wall shows a negative slope along the other extreme regardless of the closed loop control system. Dilution zone shows the hardness greater than both the substrate and the wall. The specimens fabricated without the use of closed loop con- trol were found to be denser than their counterparts. This was found to be true also in case of manual reduction of power during each layer.