A new type of u-methoxy-functionalized oligo-(OCT) and poly-(PQ) hexylthiophene characterized by a tetrameric repeating unit was synthesized and characterized. The configurational regularity and the mean degree of functionalization per thiophenic ring, lower than in commonly synthesized PATs, permitted the obtainment of more ordered chain conformations especially in the solid (film) state. Solar cells based on OCT and PQ films (as p-donor polymeric layer) mixed with Single-walled Carbon Nanotubes (SWCNTs, used as electron-acceptor system) were prepared and investigated. A power conversion efficiency of 0.52% with a fill factor of 0.42, an open-circuit voltage of 0.48 V and a short-circuit current of 1.93 mA/cm2 under 70 mW/cm2 white light illumination is reported for the polymeric sample. The obtained performance is comparable with that of devices made with regioregular P3HT but the easiness of the monomer synthesis and polymer preparation, giving OCT and PQ with good yields, as well as the enhanced workability and filmability of the latters from diluted solutions of common organic solvents together with their low sensitivity to the environmental conditions (air oxygen, moisture, temperature) makes the synthesized materials very promising for the set-up of polymer photovoltaic cells.

New photoactive oligo- and poly-alkylthiophenes / M. Lanzi; L. Paganin; D. Caretti. - In: POLYMER. - ISSN 0032-3861. - STAMPA. - 49:(2008), pp. 4942-4948. [10.1016/j.polymer.2008.09.013]

New photoactive oligo- and poly-alkylthiophenes

LANZI, MASSIMILIANO;PAGANIN, LUISA;CARETTI, DANIELE
2008

Abstract

A new type of u-methoxy-functionalized oligo-(OCT) and poly-(PQ) hexylthiophene characterized by a tetrameric repeating unit was synthesized and characterized. The configurational regularity and the mean degree of functionalization per thiophenic ring, lower than in commonly synthesized PATs, permitted the obtainment of more ordered chain conformations especially in the solid (film) state. Solar cells based on OCT and PQ films (as p-donor polymeric layer) mixed with Single-walled Carbon Nanotubes (SWCNTs, used as electron-acceptor system) were prepared and investigated. A power conversion efficiency of 0.52% with a fill factor of 0.42, an open-circuit voltage of 0.48 V and a short-circuit current of 1.93 mA/cm2 under 70 mW/cm2 white light illumination is reported for the polymeric sample. The obtained performance is comparable with that of devices made with regioregular P3HT but the easiness of the monomer synthesis and polymer preparation, giving OCT and PQ with good yields, as well as the enhanced workability and filmability of the latters from diluted solutions of common organic solvents together with their low sensitivity to the environmental conditions (air oxygen, moisture, temperature) makes the synthesized materials very promising for the set-up of polymer photovoltaic cells.
2008
New photoactive oligo- and poly-alkylthiophenes / M. Lanzi; L. Paganin; D. Caretti. - In: POLYMER. - ISSN 0032-3861. - STAMPA. - 49:(2008), pp. 4942-4948. [10.1016/j.polymer.2008.09.013]
M. Lanzi; L. Paganin; D. Caretti
File in questo prodotto:
Eventuali allegati, non sono esposti

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11585/65146
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 35
  • ???jsp.display-item.citation.isi??? 31
social impact