Calcite veins are invariably associated with en-echelon kimberlite dyke-fracture arrays. A detailed microstructural study of veining indicates four vein types. Type I stretched or ataxial veins are defined by high aspect ratio calcite fibers that are crystallographically continuous with calcite of the kimberlite matrix wall rock, by elongated phenocrystic phlogopite with sharp crystal terminations centered on contacts between adjacent calcite fibers and by phenocrystic phlogopite that grows or extends across these veins. Type I vein mineralogy indicates syn-dilational crystallization of vein minerals in local tensional areas within the kimberlite. Vein Types II (stretched to syntaxial elongate-blocky) and III (antitaxial) indicate late crystallization vein mineral growth during subsequent or repeated dilation. Calcite fibers in Type I to Type III veins are orthogonal to the contacts of their host dykes regardless of the orientation of vein margins. Type IV calcite veins, with blocky or mosaic/polycrystalline textures, are attributed to minor post-intrusion extension, which was potentially accompanied by repeated kimberlite intrusion within a given dyke array. Syn-crystallization/syn-intrusion Type I veins and an ubiquitous dyke-parallel fracture cleavage, in a zone up to 4 m on either side of dyke contacts, suggest that en-echelon kimberlite dyke-fracture arrays occupied the approximate center of zones of active dilation within the brittle carapace of the upper crust. Type II and III veins indicate that extension or dilation continued, independently of an occupying kimberlite fluid phase, after initial intrusion. Arrested mobile hydrofracturing, under low differential stress within the upper brittle or seismic carapace of the continental crust, followed by repeated dilation of the dyke-fracture system, is proposed as a mechanism for producing the features observed in this study. The conditions constrained in this study indicate passive dyke intrusion into dilating fracture arrays during crustal extension. © 2004 Elsevier B.V. All rights reserved.

Basson, I.J., Viola, G. (2004). Passive kimberlite intrusion into actively dilating dyke-fracture arrays: Evidence from fibrous calcite veins and extensional fracture cleavage. LITHOS, 76(1-4 SPEC. ISS.), 283-297 [10.1016/j.lithos.2004.03.041].

Passive kimberlite intrusion into actively dilating dyke-fracture arrays: Evidence from fibrous calcite veins and extensional fracture cleavage

VIOLA, GIULIO
2004

Abstract

Calcite veins are invariably associated with en-echelon kimberlite dyke-fracture arrays. A detailed microstructural study of veining indicates four vein types. Type I stretched or ataxial veins are defined by high aspect ratio calcite fibers that are crystallographically continuous with calcite of the kimberlite matrix wall rock, by elongated phenocrystic phlogopite with sharp crystal terminations centered on contacts between adjacent calcite fibers and by phenocrystic phlogopite that grows or extends across these veins. Type I vein mineralogy indicates syn-dilational crystallization of vein minerals in local tensional areas within the kimberlite. Vein Types II (stretched to syntaxial elongate-blocky) and III (antitaxial) indicate late crystallization vein mineral growth during subsequent or repeated dilation. Calcite fibers in Type I to Type III veins are orthogonal to the contacts of their host dykes regardless of the orientation of vein margins. Type IV calcite veins, with blocky or mosaic/polycrystalline textures, are attributed to minor post-intrusion extension, which was potentially accompanied by repeated kimberlite intrusion within a given dyke array. Syn-crystallization/syn-intrusion Type I veins and an ubiquitous dyke-parallel fracture cleavage, in a zone up to 4 m on either side of dyke contacts, suggest that en-echelon kimberlite dyke-fracture arrays occupied the approximate center of zones of active dilation within the brittle carapace of the upper crust. Type II and III veins indicate that extension or dilation continued, independently of an occupying kimberlite fluid phase, after initial intrusion. Arrested mobile hydrofracturing, under low differential stress within the upper brittle or seismic carapace of the continental crust, followed by repeated dilation of the dyke-fracture system, is proposed as a mechanism for producing the features observed in this study. The conditions constrained in this study indicate passive dyke intrusion into dilating fracture arrays during crustal extension. © 2004 Elsevier B.V. All rights reserved.
2004
Basson, I.J., Viola, G. (2004). Passive kimberlite intrusion into actively dilating dyke-fracture arrays: Evidence from fibrous calcite veins and extensional fracture cleavage. LITHOS, 76(1-4 SPEC. ISS.), 283-297 [10.1016/j.lithos.2004.03.041].
Basson, I. J; Viola, Giulio
File in questo prodotto:
Eventuali allegati, non sono esposti

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11585/567048
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 14
  • ???jsp.display-item.citation.isi??? 15
social impact