Scratch-resistant coatings for bisphenol-A polycarbonate sheets were obtained by the sol–gel synthesis of an organic–inorganic hybrid system based on poly(ethylene oxide) and silica. The organic–inorganic hybrids were thermally cured into hard transparent coatings by using conventional and microwave (MW) ovens. Both techniques proved to be equally efficient in promoting the system’s crosslinking, as evaluated by 29Si MAS-NMR. The MW-assisted curing, however, was much faster. Photoelasticity analysis showed that MW-assisted curing causes localized overheating of the samples, inducing a state of residual plane stresses that bring about dimensional instability of the coated material. Instrumented scratch tests for the coated samples revealed an increase of 1 order of magnitude in the minimal load at which a scratch track appears on the sample surface. However, the friction coefficient values for samples with thermally cured coatings were lower than those produced by MW-assisted curing.

Enhancing the scratch resistance of polycarbonate with poly(ethylene oxide)-silica hybrid coatings / P. Fabbri; M. Messori; M. Toselli; P. Veronesi; J. Rocha; F. Pilati. - In: ADVANCES IN POLYMER TECHNOLOGY. - ISSN 0730-6679. - STAMPA. - 27:2(2008), pp. 117-126. [10.1002/adv.20122]

Enhancing the scratch resistance of polycarbonate with poly(ethylene oxide)-silica hybrid coatings

FABBRI, PAOLA;TOSELLI, MAURIZIO;
2008

Abstract

Scratch-resistant coatings for bisphenol-A polycarbonate sheets were obtained by the sol–gel synthesis of an organic–inorganic hybrid system based on poly(ethylene oxide) and silica. The organic–inorganic hybrids were thermally cured into hard transparent coatings by using conventional and microwave (MW) ovens. Both techniques proved to be equally efficient in promoting the system’s crosslinking, as evaluated by 29Si MAS-NMR. The MW-assisted curing, however, was much faster. Photoelasticity analysis showed that MW-assisted curing causes localized overheating of the samples, inducing a state of residual plane stresses that bring about dimensional instability of the coated material. Instrumented scratch tests for the coated samples revealed an increase of 1 order of magnitude in the minimal load at which a scratch track appears on the sample surface. However, the friction coefficient values for samples with thermally cured coatings were lower than those produced by MW-assisted curing.
2008
Enhancing the scratch resistance of polycarbonate with poly(ethylene oxide)-silica hybrid coatings / P. Fabbri; M. Messori; M. Toselli; P. Veronesi; J. Rocha; F. Pilati. - In: ADVANCES IN POLYMER TECHNOLOGY. - ISSN 0730-6679. - STAMPA. - 27:2(2008), pp. 117-126. [10.1002/adv.20122]
P. Fabbri; M. Messori; M. Toselli; P. Veronesi; J. Rocha; F. Pilati
File in questo prodotto:
Eventuali allegati, non sono esposti

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11585/78236
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 27
  • ???jsp.display-item.citation.isi??? 23
social impact